Garage Door Remote or Keypad Not Working: What to Check
A dead remote or keypad is often a battery or a lost pairing. Work through these checks before you call, and know when the opener itself is the problem.
You press the remote and nothing happens. The keypad by the door is just as unresponsive. The wall button inside the garage still works, so the door itself is fine, but the wireless controls have stopped. This is one of the most common garage door complaints, and it is also one of the easiest to diagnose, because the cause is usually in the remote, the keypad, or the opener's receiver, rather than in the door. Work through these checks in order, and you may fix it in a few minutes.
Check the battery first
Check the lock button and the opener settings
Many wall controls have a lock button that disables the remote and keypad while leaving the wall button working. It is easy to press by accident, especially if the wall control is near a light switch. If the lock is on, the remote and keypad will not work until it is switched off. Check the wall control for a lock or vacation mode and make sure it is off. Also check whether the opener's antenna wire, which hangs from the motor unit, is damaged or tucked away. The antenna needs to hang down freely for the remote signal to reach it. If the antenna is damaged, the remote's range will be very short, and a contractor can replace it.
Re-pairing the remote or keypad
If the battery is new and the lock is off, the remote or keypad may have lost its pairing with the opener. This can happen after a power cut, a battery change, or if the opener's memory was cleared. Re-pairing usually involves pressing a learn button on the opener motor unit, then pressing the remote button or entering the keypad code within a short time. The exact steps vary by brand, and the instructions are usually on a label on the motor unit or in the opener's manual. If you are not sure, a contractor can reprogram the remote or keypad and test it. If re-pairing does not work, the remote itself may have failed, or the opener's receiver may be faulty, which our garage door opener repair page covers. A failed receiver is a repair that a contractor can diagnose by testing the opener with a known-good remote.
When the problem is the opener
If the wall button works but no remote or keypad works, and a new battery and re-pairing do not help, the problem is likely in the opener's receiver or circuit board. If the wall button does not work either, the problem is broader, and our post on a door that will not open covers the checks to make. Do not keep pressing the remote repeatedly if the opener is not responding, and do not open the opener unit yourself if you are not sure what you are doing. Call (615) 845-8263 to speak with a garage door specialist. Homeowners in Murfreesboro, TN can call and describe which controls work and which do not, and we will help connect them with an independent local contractor who can test the remotes, the keypad, and the opener.
Frequently asked questions
Why does my remote work sometimes and not others?
A weak battery is the most common cause, followed by interference or a remote that is losing its pairing. Try a new battery first.
Can I program a new remote myself?
Often, yes, by following the learn-button steps for your opener brand. If you are unsure, a contractor can program it and test it for you.
Related services
- Garage Door Opener Repair — Help with openers that hum, click, reverse, or stop responding to the remote, keypad, or wall control.
- Garage Door Repair — Help with doors that will not open, will not close, make noise, or have stopped working the way they should.
Related guides
- Garage Door Safety Sensors Explained: What They Do and Why They Matter
- Garage Door Rollers and Tracks: Maintenance That Keeps Your Door Moving
See all guides on our blog, or browse our garage door services.
Need help with your garage door? Call today.
Call now to speak with a garage door specialist about your door, or get service assistance through our contact page.